How to install lightning rods at home 2022 – How to install lightning rods at home 2022 Before delving into the three steps of how to install a lightning rod, we must remember to stick to current standard practices, such as the material used and the positioning of the correct lightning rod to cover the area/building to be placed.

There are three steps listed above , With security and convenience in mind, seek for the closest place to the lightning rod to be installed in the early phases of construction, beginning with the grounding element of the system first.

How to install lightning rods at home 2022

How to install lightning rods at home 2022 Following the determination of the grounding point, the following step is to install the drilling / earthing and ground rod material (ground rod / Cooper Rod) that will be used.

lightning rod copper

attached to the distribution wire, and the resistance / ground resistance measured using an Earth Testermeter If the measurement results reveal that the resistance / ground resistance is greater than 5 Ohms.

Then the grounding is built or added next to it and paralleled with the first grounding such that the resistance / ground resistance reduces until it reaches the standard value.

Cable / Conductor Feeding

Following the completion of the grounding, the Down Conductor distribution cable must be installed from the grounding point to the top of the building, or vice versa, taking into account the cable path closest to the grounding and avoiding numerous turns/bends 90 degrees, so that current may flow.

Surges are avoided, material requirements are reduced, and installation quality may be effective and efficient. Lightning distribution cables that are often used include BC (Bare Copper), NYY, and Coaxial. Certain areas should have a protective pipe (Conduite) installed for tidiness and safety.

Terminal for the head

If the lightning distribution cable has been carefully placed, the next step is to install the lightning terminal head/lightning rod tip, with the lightning rod tip positioned on top of the highest structure. A normal lightning rod system must be installed at a height of 60 cm to 1 meter above the structure, whereas an electrostatic lightning rod must be installed at a height of 6 meters.

above the building with the assistance of additional supporting equipment, then linked with a conductor cable to the specified grounding.